get your answers here.

If you see this, leave this form field blank and support CSS.
Reset Search



Installation Guide: DS1 Cross Aisle Panels

« Go Back



Attached Document Summary
This white 23" x 4" 100 termination panel has wire-wrap cross-connections both front and rear. The panel does not have LEDs but is equipped with a large jumper management tray and rings for complete cable management.

The DS1 Cross-Aisle Panel functions as a termination field for interconnect cables between bay line-ups for T1 or E1 signals. With Telect’s 100-terminal DS1 Cross-Aisle Panel, you can permanently connect bay line-ups with cross-aisle interconnects to avoid running individual conductors from one line-up to another. Then, when cross- connecting two DSX circuits, you need only connect each DSX circuit to the cross-aisle panel in its line-up.

Model 005-0005-0100 consists of 100 sets of 5-pin wire-wrap terminals on the front, for the line- up conductors, and a corresponding set on the rear for the cross-aisle conductors. The panel is white, 4 in. in height and mounts to a 23-in. rack with either EIA or WECO spacing.

Attached document Part No.:
119350-4 A0
Document refers to the following parts:
...Download the file below



Was this article helpful?



Please tell us how we can make this article more useful. For a response from Telect Support, please include an Email with your feedback.

Characters Remaining: 255